Swift, lesson 5
Computers are good at doing the same thing many times without getting bored. A loop runs a block of code again and again, either a set number of times or until something changes.
for-in over a rangeThe most common loop walks through a range of numbers. Each time round, the loop constant takes the next value:
1...3 includes the 3. Use 0..<count when you want to stop just before the end, which is
handy for counting from zero. The loop constant (lap here) is a new let each time round; you
cannot change it inside the loop. If you don't need it at all, write _:
To count in steps or count down, use stride. stride(from:to:by:) stops the end
value, while can include it:
2 exercises to try what you just read.
stride(from:through:by:)while and repeat-whileA while loop keeps going as long as its condition is true. It checks the condition before
each pass, so the body might never run at all:
repeat-while checks after each pass, so its body always runs at least once:
Use for-in when you know how many times to loop, and while when you only know the
condition for stopping.
Remember that readLine() returns nil when there is no more input. A while let loop uses
exactly that: it reads a line, runs the body if there was one, and stops at the end of input.
break and continuebreak exits the loop immediately. Nothing else in the loop runs.continue skips the rest of the current pass and jumps to the next one.Be careful with while loops: if nothing inside the body ever makes the condition false, the
loop runs forever and the test runner will stop your program when it runs out of time.
Read a whole number n and print its multiplication table from 1 to 10, one line each, in the
form n x i = result.
Input: one line with an integer (it may be zero or negative).
Output: ten lines.
Sample input:
Sample output:
A cashier scans prices one by one. A price of 0 means the customer is done. Add up the prices
until you see a 0 or the input ends, whichever comes first. Anything after the 0 belongs
to the next customer, so ignore it.
Input: zero or more lines, each with one whole number.
Output: two lines, Total: with the sum and Items: with how many prices were added
(the 0 itself does not count).
Sample input:
Sample output:
for lap in 1...3 {
print("Lap \(lap)")
}
// Lap 1, Lap 2, Lap 3 (each on its own line)for _ in 1...3 {
print("Hip hip hooray!")
}for n in stride(from: 10, through: 0, by: -5) {
print(n) // 10, 5, 0
}var balance = 100
var months = 0
while balance < 200 {
balance += balance / 10
months += 1
}
print("Doubled after \(months) months")var roll = 0
repeat {
roll += 2
} while roll < 5var lines = 0
while let line = readLine() {
print("Got: \(line)")
lines += 1
}
print("\(lines) lines read")for n in 1...10 {
if n % 2 == 0 {
continue // skip even numbers
}
if n > 7 {
break // stop completely
}
print(n) // 1, 3, 5, 7
}77 x 1 = 7
7 x 2 = 14
7 x 3 = 21
7 x 4 = 28
7 x 5 = 35
7 x 6 = 42
7 x 7 = 49
7 x 8 = 56
7 x 9 = 63
7 x 10 = 704
10
3
0
99Total: 17
Items: 3